The dose rate is 1 mL for each 22 lb of body weight. The formulation should be applied along the topline in a narrow strip extending from the withers to the tailhead.
Squeeze-Measure-Pour System
(8.5 fl oz/250 mL Bottle with 25 mL Metering Cup)
Attach the metering cup to the bottle.
Set the dose by turning the top section of the cup to align the correct body weight with the pointer on the knurled cap. When body weight is between markings, use the higher setting.
Hold the bottle upright and squeeze it to deliver a slight excess of the required dose as indicated by the calibration lines.
By releasing the pressure, the dose automatically adjusts to the correct level. Tilt the bottle to deliver the dose. The off (STOP) position will close the system between dosing.
Squeeze-Measure-Pour System
(33.8 fl oz/1 Liter Bottle with 50 mL Metering Cup)
Attach the metering cup to the bottle.
Set the dose by turning the top section of the cup to align the correct body weight with the pointer on the knurled cap. When body weight is between markings, use the higher setting.
Hold the bottle upright and squeeze it to deliver a slight excess of the required dose as indicated by the calibration lines.
By releasing the pressure, the dose automatically adjusts to the correct level. Tilt the bottle to deliver the dose. When 220 lb (10 mL) or 330 lb (15 mL) dose is required, turn the pointer to "STOP" before delivering the dose. The off (STOP) position will close the system between dosing.
Collapsible Pack
(84.5 fl oz/2.5 L Pack and 169 fl oz/5 L Pack)
Connect the applicator gun to the collapsible pack as follows:
Attach the open end of the draw-off tubing to the dosing equipment. (Because of the solvents used in the formulation, only the Protector Drench Gun from Instrument Supplies Limited, or equivalent, is recommended. Other applicators may exhibit compatibility problems resulting in locking, incorrect dosage or leakage.)
Replace the shipping cap with the draw-off cap and tighten down. Attach draw-off tubing to the draw-off cap.
Gently prime the applicator gun, checking for leaks.
Follow the manufacturer's directions for adjusting the dose.
When the interval between uses of the applicator gun is expected to exceed 12 hours, disconnect the gun and draw-off tubing from the product container and empty the product from the gun and tubing back into the product container. To prevent removal of special lubricants from the Protector Drench Gun, the gun and tubing must not be washed.
20 Liter Pack
(676 fl oz/20 L Pack)
Use dosing equipment (applicator, draw-off tubing, cap with stem) compatible with IVOMEC (ivermectin) Pour-On. Other dosing equipment may be incompatible, resulting in locking, incorrect dosage and leakage. Follow the dosing equipment manufacturer's directions for adjusting the dose and proper use and maintenance of the dosing equipment. Connect the dosing applicator and the draw-off tubing to the container as follows:
Attach the open end of the draw-off tubing to an appropriate dosing applicator. Attach draw-off tubing to the cap with the stem. Replace the shipping cap with the cap having the draw-off tubing. Gently prime the dosing applicator, checking for leaks.
When the interval between uses of the applicator gun is expected to exceed 12 hours, disconnect the gun, draw-off tubing and cap with stem from the product container, empty the product from the gun and tubing back into the product container and replace the shipping cap.