Benzefoam Ultra label

Benzefoam Ultra

Benzefoam Ultra Recall

Get an alert when a recall is issued.

Side Effects & Adverse Reactions

This drug should not be used in patients with vascular disease, especially disease of the coronary arteries, except with extreme caution. In such patients, even small doses may precipitate anginal pain, and with larger doses, the possibility of myocardial infarction should be considered.

Vasopressin may produce water intoxication. The early signs of drowsiness, listlessness, and headaches should be recognized to prevent terminal coma and convulsions.

FDA Safety Alerts

There are currently no FDA safety alerts available for this drug.

Manufacturer Warnings

There is currently no manufacturer warning information available for this drug.

FDA Labeling Changes

There are currently no FDA labeling changes available for this drug.

Uses

Pitressin is indicated for prevention and treatment of postoperative abdominal distention, in abdominal roentgenography to dispel interfering gas shadows, and in diabetes insipidus.

History

There is currently no drug history available for this drug.

Other Information

Pitressin (Vasopressin Injection, USP) Synthetic is a sterile, aqueous solution of synthetic vasopressin (8-Arginine vasopressin) of the posterior pituitary gland. It is substantially free from the oxytocic principle and is standardized to contain 20 USP units/mL. The solution contains 0.5% Chlorobutanol (chloroform derivative) as a preservative. The acidity of the solution is adjusted with acetic acid.

Benzefoam Ultra Manufacturers

  • Onset Dermatologics Llc
    Benzefoam Ultra | Par Pharmaceutical, Inc.
    No Recall

    Benzefoam Ultra | Par Pharmaceutical, Inc.

    Benzefoam Ultra | Par Pharmaceutical, Inc.

    Pitressin may be administered subcutaneously or intramuscularly.

    Ten units of Pitressin (0.5 mL) will usually elicit full physiologic response in adult patients; 5 units will be adequate in many cases. Pitressin should be given intramuscularly at 3- or 4-hour intervals as needed. The dosage should be proportionately reduced for pediatric patients. (For an additional discussion of dosage, consult the sections below.)

    When determining the dose of Pitressin for a given case, the following should be kept in mind.

    It is particularly desirable to give a dose not much larger than is just sufficient to elicit the desired physiologic response. Excessive doses may cause undesirable side effects—blanching of the skin, abdominal cramps, nausea—which, though not serious, may be alarming to the patient. Spontaneous recovery from such side effects occurs in a few minutes. It has been found that one or two glasses of water given at the time Pitressin is administered reduce such symptoms.

    Abdominal Distention

    In the average postoperative adult patient, give 5 units (0.25 mL) initially; increase to 10 units (0.5 mL) at subsequent injections if necessary. It is recommended that Pitressin be given intramuscularly and that injections be repeated at 3- or 4-hour intervals as required. Dosage to be reduced proportionately for pediatric patients.

    Pitressin used in this manner will frequently prevent or relieve postoperative distention. These recommendations apply also to distention complicating pneumonia or other acute toxemias.

    Abdominal Roentgenography

    For the average case, two injections of 10 units each (0.5 mL) are suggested. These should be given two hours and one-half hour, respectively, before films are exposed. Many roentgenologists advise giving an enema prior to the first dose of Pitressin.

    Diabetes Insipidus

    Pitressin may be given by injection or administered intranasally on cotton pledgets, by nasal spray, or by dropper. The dose by injection is 5 to 10 units (0.25 to 0.5 mL) repeated two or three times daily as needed. When Pitressin is administered intranasally by spray or on pledgets, the dosage and interval between treatments must be determined for each patient.