Bss Plus label

Bss Plus

Bss Plus Recall

Get an alert when a recall is issued.

Add Info

Side Effects & Adverse Reactions

For IRRIGATION during ophthalmic surgery only. Not for injection or intravenous infusion. Do not use unless product is clear, seal is intact, vacuum is present and container is undamaged. Do not use if product is discolored or contains a precipitate.

Add Info

FDA Safety Alerts

There are currently no FDA safety alerts available for this drug.

Add Info

Manufacturer Warnings

There is currently no manufacturer warning information available for this drug.

Add Info

FDA Labeling Changes

There are currently no FDA labeling changes available for this drug.

Add Info

Uses

BSS PLUS is indicated for use as an intraocular irrigating solution during intraocular surgical procedures involving perfusion of the eye.

Add Info

History

There is currently no drug history available for this drug.

Add Info

Other Information

BSS PLUS® is a sterile intraocular irrigating solution for use during all intraocular surgical procedures, including those requiring a relatively long intraocular perfusion time (e.g., pars plana vitrectomy, phacoemulsification, extracapsular cataract extraction/lens aspiration, anterior segment reconstruction, etc.). The solution does not contain a preservative and should be prepared just prior to use in surgery.

Part I: Part I is a sterile 240 mL solution in a 250 mL single-dose bottle to which the Part II concentrate is added. Each mL of Part I contains: sodium chloride 7.44 mg, potassium chloride 0.395 mg, dibasic sodium phosphate 0.433 mg, sodium bicarbonate 2.19 mg, hydrochloric acid and/or sodium hydroxide (to adjust pH), in water for injection.

Part II: Part II is a sterile concentrate in a 10 mL single-dose vial for addition to Part I. Each mL of Part II contains: calcium chloride dihydrate 3.85 mg, magnesium chloride hexahydrate 5 mg, dextrose 23 mg, glutathione disulfide (oxidized glutathione) 4.6 mg, in water for injection.

After addition of BSS PLUS Part II to the Part I bottle, each mL of the reconstituted product contains: sodium chloride 7.14 mg, potassium chloride 0.38 mg, calcium chloride dihydrate 0.154 mg, magnesium chloride hexahydrate 0.2 mg, dibasic sodium phosphate 0.42 mg, sodium bicarbonate 2.1 mg, dextrose 0.92 mg, glutathione disulfide (oxidized glutathione) 0.184 mg, hydrochloric acid and/or sodium hydroxide (to adjust pH), in water for injection.

The reconstituted product has a pH of approximately 7.4. Osmolality is approximately 305 mOsm.

Add Info
Add to My Alerts
Report Side Effect
Leave a Review
Navigate to :
Bss Plus Recall
Side Effects & Adverse Reactions
Legal Issues
FDA Safety Alerts
Manufacturer Warnings
FDA Labeling Changes
Uses
History
Other Information
Manufacturers
Trending Topics

Bss Plus Manufacturers

  • Alcon Laboratories, Inc.
    Bss Plus | Alcon Laboratories, Inc.
    No Recall

    Bss Plus | Alcon Laboratories, Inc.

    Bss Plus | Alcon Laboratories, Inc.

    The solution should be used according to the standard technique employed by the operating surgeon. Use an administration set with an air-inlet in the plastic spike since the bottle does not contain a separate airway tube. Follow the directions for the particular administration set to be used. Insert the spike aseptically into the bottle through the center target area of the rubber stopper. Allow the fluid to flow to remove air from the tubing before intraocular irrigation begins. If a second bottle is necessary to complete the surgical procedure, ensure that the vacuum is vented from the second bottle BEFORE attachment to the administration set.

  • Alcon Laboratories, Inc.
    Bss Plus | Alcon Laboratories, Inc.
    No Recall

    Bss Plus | Alcon Laboratories, Inc.

    Bss Plus | Alcon Laboratories, Inc.

    The solution should be used according to the standard technique employed by the operating surgeon. Use an administration set with an air-inlet in the plastic spike since the bottle does not contain a separate airway tube. Follow the directions for the particular administration set to be used. Insert the spike aseptically into the bottle through the center target area of the rubber stopper. Allow the fluid to flow to remove air from the tubing before intraocular irrigation begins. If a second bottle is necessary to complete the surgical procedure, ensure that the vacuum is vented from the second bottle BEFORE attachment to the administration set.

  • Alcon Laboratories, Inc.
    Bss Plus | Alcon Laboratories, Inc.
    No Recall

    Bss Plus | Alcon Laboratories, Inc.

    Bss Plus | Alcon Laboratories, Inc.

    The solution should be used according to the standard technique employed by the operating surgeon. For non-active irrigating system, use an administration set with an air-inlet in the plastic spike since the bag does not contain a separate airway tube. Follow the directions for the particular administration set to be used. Insert the spike aseptically into the bag through the center target area of the rubber stopper. Allow the fluid to flow to remove air from the tubing before intraocular irrigation begins.

Login To Your Free Account