Bss label

Bss

Bss Recall

Get an alert when a recall is issued.

Side Effects & Adverse Reactions

• NOT FOR INJECTION OR INTRAVENOUS INFUSION.

• Do not use unless product is clear, seal is intact, vacuum is present and container is undamaged.

• Do not use if product is discolored or contains a precipitate.

• SINGLE patient use only. The contents of this bottle should not be used in more than one patient.

• The use of additives with this solution may cause corneal decompensation.

• This solution contains no preservative, unused contents should be discarded.

FDA Safety Alerts

There are currently no FDA safety alerts available for this drug.

Manufacturer Warnings

There is currently no manufacturer warning information available for this drug.

FDA Labeling Changes

There are currently no FDA labeling changes available for this drug.

Uses

For use as an extraocular and intraocular irrigating solution during ocular surgical procedure involving perfusion of the eye with an expected maximum duration of less than 60 minutes.

History

There is currently no drug history available for this drug.

Other Information

BSS® Sterile Irrigating Solution is a sterile balanced salt solution, each mL containing sodium chloride (NaCl) 0.64%, potassium chloride (KCl) 0.075%, calcium chloride dihydrate (CaCl2•2H2O) 0.048%, magnesium chloride hexahydrate (MgCl2•6H2O) 0.03%, sodium acetate trihydrate (C2H3NaO2•3H2O) 0.39%, sodium citrate dihydrate (C6H5Na3O7•2H2O) 0.17%, sodium hydroxide and/or hydrochloric acid (to adjust pH), and water for injection. The pH is approximately 7.5. The osmolality is approximately 300 mOsm/Kg.

Bss Manufacturers

  • Bss | Alcon Laboratories, Inc.
    No Recall

    Bss | Alcon Laboratories, Inc.

    Bss | Alcon Laboratories, Inc.

    This irrigating solution should be used according to standard format for each surgical procedure. Note: Use an administration set with an air-inlet in the plastic spike since the bottle does not contain a separate airway tube. Follow directions of the particular administration set to be used. Remove the blue flip-off cap. Clean and disinfect the rubber stopper by using a sterile alcohol wipe. Insert the spike aseptically into the bottle through the target area of the rubber stopper. Allow the fluid to flow and remove air from the tubing before irrigation begins.

  • Bss | Alcon Laboratories, Inc.
    No Recall

    Bss | Alcon Laboratories, Inc.

    Bss | Alcon Laboratories, Inc.

    The adapter plug is designed to accept an irrigating needle. Tissues may be irrigated by attaching the needle to the DROP-TAINER® bottle as explained below. External irrigation may be done without the irrigating needle.

    Method of using Adapter Plug for LUER-LOK* Hub Ophthalmic Irrigating Needle:

    1. Aseptically remove DROP-TAINER bottle from blister by peeling paper backing.

    2. Snap on surgeon's sterile irrigation needle. Push until firmly in place and twist slightly.

    3. Test assembly for proper function before use.

    *NOTE: LUER-LOK is a registered trademark of Becton, Dickinson and Company.

  • Bss | Alcon Laboratories, Inc.
    No Recall

    Bss | Alcon Laboratories, Inc.

    Bss | Alcon Laboratories, Inc.

    This irrigating solution should be used according to standard format for each surgical procedure. Follow directions of the particular administration set to be used. Remove the outer overwrap. Clean and disinfect the rubber stopper by using a sterile alcohol wipe. Insert the spike aseptically into the bag through the target area of the rubber stopper. Allow the fluid to flow and remove air from the tubing before irrigation begins.