Sulfamed

Sulfamed Manufacturers

• Bimeda, Inc. Division Of Cross Vetpharm Group
  

  ×

  Sulfamed | Bimeda, Inc. Division Of Cross Vetpharm Group

  

  ---

  SulfaMed™ Injection 40% must be administered only by the intravenous route in cattle. Cattle should receive 1 mL of SulfaMed™ Injection 40% per 16 lb of body weight (55 mg/kg) as an initial dose, followed by 0.5 mL per 16 lb of body weight (27.5 mg/kg) every 24 hours thereafter. Sulfadimethoxine Boluses may be utilized for maintenance therapy in cattle. Representative weights and doses are indicated in the following table:

  Each mL contains 400 mg sulfadimethoxine Animal Weight Initial Dose 25 mg/lb (55 mg/kg) Subsequent Daily Doses 12.5 mg/lb (27.5 mg/kg) 250 lb (113.6 kg) 15.6 mL 7.8 mL 500 lb (227.2 kg) 31.2 mL 15.6 mL 750 lb (340.9 kg) 46.9 mL 23.5 mL 1000 lb (454.5 kg) 62.5 mL 31.3 mL

  Length of treatment depends on the clinical response. In most cases treatment for 3 - 5 days is adequate. Treatment should be continued until the animal is asymptomatic for 48 hours.

  Equipment needed A nose lead and/or halter sufficiently strong enough to effectively restrain or hold the animal’s head steady so that the intravenous injection can be made with ease. Hypodermic needles, 16 or 18 gauge and 2 inches long. Only new, sharp and sterile hypodermic needles should be used. Dull needles should be discarded. Extra needles should always be available in case the needle being used should become clogged. Hypodermic syringes, 40- or 50-mL sterile, disposable or reusable glass syringes should be available. Alcohol (70%) or equally effective antiseptic for disinfecting the skin. Preparation of equipment

  Glass syringes and regular hypodermic needles should be thoroughly cleaned and washed. Following this, the needles and syringes should be immersed in boiling water for 30 minutes prior to each injection. Regular hypodermic needles should not be used more than 3-4 times as repeated skin puncturing and boiling of the needles causes them to become quite dull. Disposable hypodermic needles and syringes should not be used more than once.

  Restraint of animal

  The cow should preferably be in a stanchion for maximum restraint. If this is not possible, the animal should be restrained in a manner to prevent excessive movement. A nose lead should be applied and the animal’s head turned sidewise to stretch the skin and tense the muscles of the neck region (See Figure 1).

  Locating the jugular vein

  Once the animal has been restrained (as above), you will notice a long depression of the skin from below the angle of the jaw to just above the shoulder. This is known as the jugular furrow or jugular groove. The jugular vein is located just under the jugular groove (See Figure 1).

  Preparation of SulfaMed™ Injection 40% for injection

  The rubber cap of the bottle should be thoroughly cleaned with 70% alcohol or other satisfactory antiseptic. The correct amount of SulfaMed™ Injection 40% for treatment should be calculated (see dosage directions) and that amount withdrawn into a syringe (See Figure 2). One or two syringefuls of air should be injected into the bottle first to make withdrawing the drug easier. SulfaMed™ Injection 40% should preferably be at room temperature when filling syringes and when injecting intravenously.

  Entering the vein

  The skin of the injection area should be clean and free of dirt. Cotton saturated with 70% alcohol (or suitable antiseptic) should be used to wipe the injection site. Apply pressure over the jugular vein close to the shoulder. This will reduce the flow of blood to the heart and cause the jugular vein to bulge or enlarge (See Figure 3). When the jugular vein has been “raised”, insert the hypodermic needle at a 45° angle through the skin just underneath the jugular vein. The beveled edge of the hypodermic needle should be up (See Figure 4).

  After the skin has been punctured, the point of the needle should be directed toward the side of the vein and pushed into the center of the vein (See Figure 5). When the needle is in the center of the vein, there will be free flow of blood back through the needle. Release external pressure when you are sure the needle is within the vein.

  Injecting the SulfaMed™ Injection 40%

  After the needle has been accurately inserted into the jugular vein, firmly attach the syringe containing SulfaMed™ Injection 40% to the inserted hypodermic needle. Caution; be sure syringe is free of air. Exert firm pressure on the plunger of the syringe to inject the SulfaMed™ Injection 40% while the barrel is held firmly. The injection should be made moderately slow - never rapidly. If the animal moves, causing resistance in pushing the plunger of the syringe, or if a bubble of the drug is noted under the skin, the needle is no longer within the vein. The needle should be repositioned.

  When the injection is completed, quickly withdraw the syringe and needle with a quick pull and apply light pressure over the injection site with alcohol and cotton to minimize bleeding from the puncture site.

  Close
  No Recall

  More Info
• Vetone
  

  ×

  Sulfamed | Vetone

  

  ---

  DOSAGE AND ADMINISTRATION:  SulfaMedTM Injection 40% must be administered only by the intravenous route in cattle.  Cattle should receive 1 mL of SulfaMedTM Injection 40% per 16 lb of body weight (55 mg/kg) as an initial dose, followed by 0.5 mL per 16 lb of body weight (27.5 mg/kg) every 24 hours thereafter.  Sulfadimethoxine Boluses may be utilized for maintenance therapy in cattle.  Representative weights and doses are indicated in the following table:

  Each mL contains 400 mg sulfadimethoxine

  _____________________________________________________________________________________

  Animal Weight                                       Initial Dose                                         Subsequent Daily Doses

                                                             25 mg/lb (55 mg/lg)                            12.5 mg/lb (27.5 mg/kg)

  250 lb (113.6 kg)                                  15.6 mL                                              7.8 mL

  500 lb (227.2 kg)                                  31.2 mL                                              15.6 mL

  750 lb (340.9 kg)                                  46.9 mL                                              23.5 mL

  1000 lb (454.5 kg)                                62.5 mL                                              31.3 mL

  ______________________________________________________________________________________  

  Length of treatment depends on the clinical response.  In most cases treatment for 3 - 5 days is adequate.  Treatment should be continued until the animal is asymptomatic for 48 hours.

  DIRECTIONS FOR INTRAVENOUSE INJECTION:

  1.  A nose lead and/or halter sufficiently strong enough to effectively restrain or hold the animal's head steady so that the intravenous injection can be made with ease.

  2.  Hypodermic needles, 16 or 18 gauge and 2 inches long.  Only new, sharp and sterile hypodermic needles should be used.  Dull needles should be discarded.  Extra needles should always be available in case the needle being used should become clogged.

  3.  Hypodermic syringes, 40- or 50-mL sterile, disposable or resusable glass syringes should be available.

  4.  Alcohol (70%) or equally effective antiseptic for disinfecting the skin.

  Preparation of equipment:  Glass syringes and regular hypodermic needles should be thoroughly cleaned and washed.  Following this, the needles and syringes should be immersed in boiling water for 30 minutes prior to each injection.  Regular hypodermic needles should not be used more than 3-4 times as repeated skin puncturing and boiling of the needles casues them to become quite dull.  Disposable hypodermic needles and syringes should not be used more than once.      

  Restraint of animals:  The cow should preferable be in a stancion for maximum restraint.  If this is not possible, the animal should be restrained in a manner to prevent excessive movement.  A nose lead should be applied and the animal's head turned sidewise to stretch the skin and tense the muscles of the neck region (See Figure 1).

  Locating the jugular vein:  Once the animal has been restrained (as above), you will notice a long depression of the skin from below the angle of the jaw to just above the shoulder.  This is known as the jugular furrow or jugular groove.  The jugular vein is located just under the jugular groove (See Figure 1).

  Preparation of SulfaMedTM Injection 40% for injection:  The rubber cap of the bottle should be thoroughly cleaned with 70% alcohol or other satisfactory antiseptic.  The correct amount of SulfaMedTM of SulfaMedTM injection 40% for treatment should be calculated (see dosage directions) and that amount withdrawn into a syringe (See Figure 2).  One or two syringefuls of air should be injected into the bottle first to make withdrawing the drug easier.  SulfaMedTM Injection 40% should preferably be at room temperature when filling syringes and when injecting intravenously.

  Entering the vein:  The skin of the injection area should be clean and free of dirt.  Cotton saturated with 70% alcohol (or suitable antiseptic) should be used to wipe the injection site.  Apply pressure over the jugular vein close to the shoulder.  This will reduce the flow of blood to the heart and cause jugular vein to bulge or enlarge (See Figure 3).  When the jugular vein has been "raised", insert the hypodermic needle at a 45° angle through the skin just underneath the jugular vein.  The beveled edge of the hypodermic needle should be up (See Figure 4).

  After the skin has been punctured, the point of the needle should be directed toward the side of the vein and pushed into the center of the vein (See Figure 5).  When the needle is in the center of the vein, there will be free flow of blood back through the needle.  Release external pressure when you are sure the needle is within the vein.

  Injection the SulfaMedTM Injection 40%:  After the needle has been accurately inserted into the jugular vein, firmly attach the syringe containing SulfaMedTM Injection 40% to the inserted hypodermic needle.  Caution, be sure syringe is free of air.  Exert firm pressure on the plunger of the syringe to inject the SulfaMedTM Injection 40% while the barrel is held firmly.  The injection should be made moderately slow - never rapidly.  If the animal moves, causing resistance in pushing the plunger of the syringe, or if a bubble of the drug is noted under the skin, the needles is no longer within the vein.  The needle should be repositioned.

  When the injection is completed, quickly withdraw the syringe and needle with a quick pull and apply light pressure over the injection site with alcohol and cotton to minimize bleeding from the puncture site.

  Close
  No Recall

  More Info
• Aspen Veterinarian Resources
  

  ×

  Sulfamed | Aspen Veterinarian Resources

  

  ---

  SulfaMed™ Injection 40% must be administered only by the intravenous route in cattle. Cattle should receive 1 mL of SulfaMed™ Injection 40% per 16 lb of body weight (55 mg/kg) as an initial dose, followed by 0.5 mL per 16 lb of body weight (27.5 mg/kg) every 24 hours thereafter. Sulfadimethoxine Boluses may be utilized for maintenance therapy in cattle. Representative weights and doses are indicated in the following table:

  Each mL contains 400 mg sulfadimethoxine

  Animal Weight

  Initial Dose 25 mg/lb (55 mg/kg)

  Subsequent Daily Doses 12.5 mg/lb (27.5 mg/kg)

      250 lb (113.6 kg) 

                         15.6 mL

                                             7.8 mL

      500 lb (227.2 kg)

                         31.2 mL

                                           15.6 mL

      750 lb (340.9 kg)

                         46.9 mL

                                           23.5 mL

      1000 lb (454.5 kg)

                         62.5 mL

                                           31.3 mL

  Length of treatment depends on the clinical response. In most cases treatment for 3 - 5 days is adequate. Treatment should be continued until the animal is asymptomatic for 48 hours.

  Close
  No Recall

  More Info