Vanquish Barrier Activator

Vanquish Barrier Activator Manufacturers

• Delaval Inc.
  

  ×

  Vanquish Barrier Activator | Delaval Inc.

  

  ---

  GENERAL INSTRUCTIONS

  Use mixed solution at full strength (do not dilute). Do not use base or activator alone on cow teats. Consult your veterinarian before using a teat dip on a cow with sore or chapped teats. Thoroughly clean and sanitize teat dip cup before milking. Use fresh teat dip for each milking.  Dip solution should be changed if it becomes visibly dirty, or if sediment is introduced. Do not pour used teat dip back into original container. Do not use for cleaning or sanitizing equipment. MIXING DIRECTIONS:  Using a manual pump or automatic system, mix 1 part Vanquish Barrier BASE and 1 part Vanquish Barrier ACTIVATOR into a clean teat cup or container at least 30 minutes prior to use.  Mix product until color is uniform.  Prepare only the quantity needed for one milking.

  PRE-DIPPING

  For optimal removal of organic debris and to remove any residual Vanquish Barrier, use mixed Vanquish Pre Post sanitizing teat dip, following label instructions.

  POST-DIPPING

  Immediately after removing milking unit, dip or spray teats with Vanquish Barrier teat dip.  Do not wipe. If outside temperature is below freezing, allow Vanquish Barrier teat dip to air-dry on cow's teats before cow is released outside; or allow teat dip to remain on teats for one minute, then dry teats with a single-service paper towel.  Failure to follow these directions may result in frozen teats and injured animals.

  Close
  No Recall

  More Info