Vanquish Pre-post Activator

Vanquish Pre-post Activator Manufacturers

• Delaval Inc.
  

  ×

  Vanquish Pre-post Activator | Delaval Inc.

  

  ---

  USE DIRECTIONS
  
  MIXING INSTRUCTIONS
  Using a manual pump or automatic system, mix 1 part of Vanquish™ Pre Post BASE and 1 part of Vanquish™ Pre Post ACTIVATOR into a clean teat cup or container at least 30 minutes prior to use. Mix product until color is uniform. Prepare only the quantity needed for one milking. GENERAL INSTRUCTIONS
  Use mixed solution at full strength (do not dilute). Do not use base or activator alone on cow teats. Consult your veterinarian before using a teat dip on a cow with sore or chapped teats. Use fresh teat dip for each milking. Dip solution should be changed if it becomes visibly dirty, or if sediment is introduced. Do not pour used teat dip back into original container. Do not use for cleaning or sanitizing equipment. To discard unused teat dip, dilute with water and pour down the drain.
  PRE-DIPPING
  Remove excess soil and forestrip. (If water is used, use a minimal amount and dry thoroughly with a clean, single-service paper towel before forestripping). Dip teats with mixed Vanquish™ Pre Post teat dip to base of udder. Allow a 15 to 30 second contact time. Dry teats thoroughly with a clean, single service paper towel. Attach milking unit.
  POST-DIPPING
  Immediately after removing milking unit, dip or spray teats with Vanquish™ Pre Post teat dip. Do not wipe. If outside temperature is below freezing, allow Vanquish• ™ Pre Post teat dip to air-dry on cow’s teats before cow is released outside; or allow teat dip to remain on teats for one minute, then dry teats with a single-service paper towel. Failure to follow these directions may result in frozen teats and injured animals.
  
  

  Close
  No Recall

  More Info